Xylem 19 001 351R2 PACE Integrated Pump Controller Human Machine Interface (HMI) for the Silent Storm VFD Pumping System – User Guide User Manual
Page 21
21
Figure 47: Database Settings
After enabling the database connection, the HMI
must be restarted with the Gateway software
running on the host irrigation computer. This can
be accomplished through cycling power or by
shutting down and restarting the application.
Email Settings
This page allows you to set up email addresses
where Alarm and shutdown messages will be sent.
These emails will notify the user if the station has
shut down or experienced a problem that the site
personnel should be aware of. This way the user
will be notified immediately in case of a pump
station problem. If a fault occurs, an email will be
sent to him.
The email settings can be configured to send
emails to multiple individuals or email addresses.
The vast majority of cell phone providers also allow
email messages to be sent to cell phones as text
messages. A list of known formats is provided
below.
Enable: Check this box to enable email alarms
from the Pace controls.
Use Authentication: Check this box if your email
service requires POP3 authentication.
Note: The IP address of the POP3 server must be
the same as the IP address of the SMTP server.
This is usually the case (both servers usually reside
behind the same firewall/router).
To: Enter the email address to send the alarm
messages to. Multiple email addresses can be
entered by separating the email addresses with a
semicolon.
Examples:
;
;
;
.
The following list shows email address formats for
various cell carriers. Sending an email to these
addresses will generate an SMS text message to
the cellular phone.
T-Mobile: [email protected]
Virgin Mobile: [email protected]
Cingular: [email protected]
Sprint: [email protected]
Verizon: [email protected]
Nextel: [email protected]
US Cellular: [email protected]
SunCom: [email protected]
Powertel: [email protected]
AT&T: [email protected]
Alltel: [email protected]
Metro PCS: [email protected]
Where “phonenumber” is the 10 digit phone number
of the user.
SMTP: Enter the IP address of the SMTP server
you will be using. Windows CE devices require the
IP address rather than the server name.
See “Determining the IP address of the SMTP
server” in Appendix F for these instructions.
From: Enter the complete email address used for
this service. Most email servers will ignore your
email request if the “From” address does not match
the account.
Example: [email protected]
User: For most email service providers, enter the
first part of the email address without the domain
name. Note that some providers require the full
email address as your user name.
Example: mypumpstation
Password: The password to your email account.
Example: flowtronex
After configuring your email settings, test the setup.
Tap [Set] to load the information into the email
generator. Then tap [Send]. A test email will be
immediately sent to the address(es) provided.
If the colored box remains green after hitting Send,
the configurations are working correctly. If the box
turns red there has been an error. The number after
“Status” indicates the type of error, table for which
can be found in Appendix F. Additional
troubleshooting options for email configuration can
also be found in Appendix F.