YSI DIQ/S 182 XT-4-PR - Manual (Page 121)

System 182 XT-4 PROFIBUS connection
7 - 5 ba76027e01 02/2012
7.3 Setting the PROFIBUS address
Proceeding:
Setting the PROFIBUS
address on the
DIQ/S 182 XT-4-PR
Note
To accept all settings, highlight the Save and quit menu item at the
lower end of the setting table and press
g
. If you exit the setting table
via
m
,
e
/Quit or the Quit menu item, all changes are ignored.
7.4 GSD file
The GSD file contains all necessary information on the Profibus module
and is required by the configuration program of the Profibus master.
The GSD file for the IQ S ENSOR N ET is found on the CD-ROM provided
(file name: IQMC06D1.GSD). The current GSD file is also provided on
the Internet under
www.ysi.com .
1 Open the SETTINGS menu with
s
.
2 Select and confirm the PROFIBUS config. menu item with
w
and
g
.
3 Edit the setting table as described in section 4.3.2.