YSI DIQ/S 182 XT-4-PR User Manual
Page 35
Advertising
System 182 XT-4
Installation
3 - 21
ba76027e01
02/2012
Fig. 3-13 Connect cable (example: rear terminal strip)
Note
The complete assignment of the terminal strip is shown in section 3.14.
3
Screw a cable gland (pos. 1 in Fig. 3-13) with the sealing ring
(pos. 2) into the enclosure.
4
Loosen the coupling ring (pos. 3 in Fig. 3-13).
5
Feed the cable through the cable gland into the enclosure.
6
Connect the cable ends to the terminal strip. At the same time,
look out for the designations of the terminals (red / shield /
green).
7
Tighten the coupling ring (pos. 3 in Fig. 3-13).
8
Close the enclosure.
SENSORNET 1
SACIQ
SNCIQ
SNCIQ/UG
1
3
2
SENSORNET 2
Advertising