Xylem IQ SensorNet FDO 70x IQ (SW) - Manual (Page 15)

FDO
®
70x IQ (SW) Commissioning
3 - 3 ba76014e01 02/2012
3.3 Commissioning / Getting the instrument ready for
measuring
Identification in the
IQ S ENSOR N ET
Both the sensor cap and sensor basis (sensor without cap) have a
series number of their own. The sensor has to be equipped with a sen-
sor cap for a successful login to the IQ S
ENSOR N ET . The operable sen-
sor is displayed as follows in the list of sensors:
Commissioning steps
 Model: Model designation of the sensor cap
(="SC FDO 70x")
 Ser. no.: Series number of the sensor cap
 Sensor name: The series number of the sensor basis is preset
here. You can change this entry as necessary by
entering a user-defined name.
1 Pull the protective cap off the sensor.
2 If required, assign a user-defined name to the sensor (see rel-
evant IQ S
ENSOR N ET system operating manual).
3 When using IQ S ENSOR N ET without automatic air
pressure compensation the mean air pressure value or the
location altitude has to be entered (for more detailed informa-
tion see the relevant IQ S
ENSOR N ET system operating man-
ual).
4 Set the sensor (see section 3.4).