YSI IQ SensorNet MIQ/IC2 Module - Manual (Page 9)

MIQ/IC2 Installation
3 - 1 ba76034e01 01/2012
3 Installation
3.1 Scope of delivery
The scope of delivery of the MIQ/IC2 is listed in the I NSTALLATION
chapter of the system operating manual.
3.2 Installation in the IQ S ENSOR N ET
The IQ S ENSOR N ET provides a number of options to integrate the MIQ/
IC2 mechanically and electrically in the system (stacked mounting,
distributed mounting, etc.). The various types of installation are
described in detail in the I
NSTALLATION chapter of the system operating
manual.
Software requirements
of the IQ S ENSOR N ET
Software requirements for the settings of Unit and Measured parame-
ter:
 Controller from version 2.58
 Terminal from version 2.55
When using older software versions, it is not possible to enter texts for
the settings of Unit and Measured parameter. The measured value
display displays the numerical value of the correlated measured value
without designation.
Note
It is possible to update the software if your components have older soft-
ware versions. Contact the YSI service department.
3.3 Connecting external meters to the current inputs
Warning
If external electrical circuits that are subject to the danger of phys-
ical contact are incorrectly connected to the current inputs, there
may be a danger of life threatening electric shock. Electrical cir-
cuits are regarded to be subject to the danger of physical contact
when there are voltages higher than the Safety Extra Low Voltage
(SELV).
General installation
instructions
Observe the following instructions when attaching connecting wires to
the terminal strip:

Shorten all the wires used to the length required for the installation.
 Fit all wire ends with wire end sleeves before connecting them to the
terminal strip.