YSI IQ SensorNet MIQ/A-PR Module - Manual (Page 13)

MIQ/(A-)PR Interface for the PROFIBUS
13 ba76020e01 01/2012
Fig. 3-6 Connection of the MIQ/(A-)PR as a PROFIBUS end device
Note
Using a shielding terminal, connect the shield of the PROFIBUS cable
to the potential equalization or grounding system of the plant in the
vicinity but outside of the MIQ module housing.
7 Fasten the cap nut of the screwed cable gland.
8 Check and if necessary correct the position of the PROFIBUS
terminator switch.
The switch must be in the ON position.
9 Perform the check:
 Check whether the wires and cables are screwed on tightly.
 Insulate open wires.
 Remove any cable remains from the MIQ/(A-)PR module.
10 Close the MIQ/(A-)PR module.
AnyBus-S module
for Profibus-DP