YSI TruLab 1310P - Manual (Page 38)

Settings TruLab pH 1310
38
ba76156e01 03/2014
7 Settings
7.1 Measurement settings
7.1.1 Changing the settings for pH measurements
The settings are made in the menu for calibration and measurement settings of
the pH/ORP measurement. To open the settings, display the required parame-
ter in the measured value display and press the <F1>/[menu] or <MENU/
ENTER> key. After completing the settings, switch to the measured value dis-
play with <M>.
Default settings are printed in bold.
Menu item Possible set-
ting Description
Calibration /Cali-
bration record - Displays the calibration record of
the last calibration.
Calibration /
Calibration data
storage /Display - Displays the calibration record.
Further options:

Scroll through the calibration
records with <><>.
 Output the displayed calibration
record to the interface with
<F2>/[USB output].
 Output all calibration records to
the interface with <F2__>[USB
output].
 Quit the display with <F1>/
[Back] or <MENU/ENTER>.
 Switch directly to the measured
value display with <M>.
Calibration / Cali-
bration data stor-
age / Output to USB - Outputs the calibration records to
the interface.
Calibration / Serial
number (probe) Entry of the serial number of the
connected sensor.
The serial number is output in the
calibration record.
 Change the content of the high-
lighted position with <><>.
 Go to the next position with
<F2>/[].
 When the serial number has
been completely entered, con-
firm with <ENTER>.