YSI TruLab 1310P User Manual
Page 21
TruLab pH 1310
Operation
ba76156e01
03/2014
21
The date format can be switched from the display of day, month, year
(dd.mm.yyyy) to the display of month, day, year (mm/dd/yyyy or mm.dd.yyyy).
After a fall of the supply voltage (empty batteries), the date and time
are reset.
1.
In the measured value display:
Using <F1__>/[Menu], open the Storage & config menu.
The instrument is in the setting mode.
2.
Select and confirm the System / Clock menu with <><> and
<MENU/ENTER>.
The setting menu for the date and time opens up.
3.
Select and confirm the Time menu with <><> and <MENU/
ENTER>.
The hours are highlighted.
4.
Change and confirm the setting with <><> and <MENU/ENTER>.
The minutes are highlighted.
5.
Change and confirm the setting with <><> and <MENU/ENTER>.
The seconds are highlighted.
6.
Change and confirm the setting with <><> and <MENU/ENTER>.
The time is set.
7.
If necessary, set the Date and Date format. The setting is made similarly
to that of the time.
8.
To make further settings, switch to the next higher menu level with
[Back]<F1>.
or
Switch to the measured value display with <M>.
The instrument is in the measuring mode.
Date format
:
dd.mm.yyyy
Date
:
01.02.2014
Time
:
08:00:25
Clock
01.02.2014
08:00
Back