YSI TruLab 1310P - Manual (Page 39)

TruLab pH 1310 Settings
ba76156e01 03/2014
39
7.1.2 Buffer sets for calibration
You can use the buffer sets quoted in the table for an automatic calibration. The
pH values are valid for the specified temperature values. The temperature
dependence of the pH values is taken into consideration during the calibration.
Calibration /Buffer YSI
ConCal
NIST/DIN
... Buffer sets to be used for pH cali-
bration (see section 5.2 C
ALIBRA
-
TION , page 25).
Calibration /One
point calibration Yes
No Quick calibration with 1 buffer
Calibration /Cali-
bration interval 1 ... 7 ... 999 d Calibration interval for the pH elec-
trode (in days).
The meter reminds you to calibrate
regularly by the flashing sensor
symbol in the measuring window.
Calibration /Unit for
slope mV/pH
% Unit of the slope.
The % display refers to the Nernst
slope of -59.2 mV/pH (100 x deter-
mined slope/Nernst slope).
Man. temperature -25 ... +25 ...
+130 °C Entry of the manually determined
temperature. For measurements
without temperature sensor only.
Temperature unit °C
°F Temperature unit,
degrees Celsius or degrees Fahr-
enheit.
All temperatures are displayed
with the selected unit.
Resolution pH 0.001
0.01
0.1 Resolution of the pH display
Stability control On
Off Switches on or off the automatic
stability control during measure-
ment (see section 5.1.1 M
EASUR -
ING THE P H VALUE , page 22)
Reset - Resets all sensor settings to the
delivery condition (see section
7.4.1 R
ESETTING THE MEASURE -
MENT SETTINGS , page 45).
Menu item Possible set-
ting Description