YSI TruLab 1310P - Manual (Page 45)

TruLab pH 1310 Settings
ba76156e01 03/2014
45
7.4.1 Resetting the measurement settings
The following settings for pH measurements are reset to the default settings
with the Reset function:
The sensor settings are reset under the Reset menu item in the menu for cali-
bration and measurement settings. To open it, press the <F1>/[Menu] or
<MENU/ENTER> key in the measured value display.
7.4.2 Resetting the system settings
The following system settings can be reset to the default condition:
The calibration data are reset to the default settings together with
the measuring parameters. Recalibrate after performing a reset.
Setting Default settings
Buffer YSI
Cal. interval 7 d
Unit for slope mV/pH
Measured parameter pH
Resolution pH 0.001
Resolution mV 0.1
Asymmetry 0 mV
Slope -59.2 mV
Man. temperature 25 °C
One point calibration No
Stability control On
Temperature unit °C
Setting Default settings
Language English
Beep On
Baud rate 4800 Baud
Output format ASCII
Contrast 50 %
Illumination Auto
Switchoff time 1 h