Extron Electronics DMS 1600_2000_3200_3600 Setup Guide - Manual (Page 10)

DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control 13 12 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Front Panel Operations
Remote Control
This section describes using the remote control features of the
DMS matrix switchers to control the devices. Topics that are covered
include:
• Selected SIS Commands
• Installing and Starting the Control Program
• Accessing the HTML Pages
Selected SIS Commands
You can use Simple Instruction Set (SIS) commands for operation and
configuration of the switchers. You can run these commands from a PC
connected to a serial port (
item e on page 8), Ethernet port ( item f on
page 8), or USB port ( item a on page 9) on the switcher.
Establishing a Network (Ethernet) Connection
NOTE: The first time you connect to the switcher via the LAN port,
you may need to change the default settings (IP address, subnet
mask, and [optional] administrator password) of the switcher.
Establish a network connection as follows:
1. Open a TCP socket to port 23 using the IP address of the switcher.
NOTE: The factory default IP address is 192.168.254.254.
The switcher responds with a copyright message including the name,
firmware version, and part number of the product, and the current
date and time.
NOTES:
• If the switcher is not password-protected, the device is now
ready to accept SIS commands.
• If the switcher is password-protected, a password prompt
appears.
2. If necessary, enter the appropriate password.
If the password is accepted, the switcher responds with Login User
or Login Administrator.
If the password is not accepted, the Password prompt reappears.
3. Press an output button. The buttons for the tied input and all tied
outputs light.
4. Press the View button again to exit View mode. All input and output
buttons return to an unlit state.
Saving or Recalling a Preset
The DMS switchers have 32 global memory presets.
1. Save a preset — Press and hold the Preset button until it flashes.
PRESET PRESET
The Preset button blinks. Press and hold.
2 seconds Save a
preset
Recall a preset — Press and release the Preset button.
PRESET PRESET
1 2 3 4 5 6 16 15
Recall a
preset
The Preset button lights. Press and release.
All input and output buttons with assigned presets light red.
When a preset is saved, the configuration data at
assigned preset locations will be overwritten.
INPUTS
2. Press and release the desired input or output button.
1 ENTER
The button blinks red to indicate that
this preset is selected to save or recall.
The Enter button blinks
red to indicate the need to
activate the save or recall.
3. Press and release the Enter button.
Locking Out the Front Panel (Executive Mode)
To toggle the front panel lock on and off, simultaneously press and hold
the Enter button and the Esc button until the Preset and View buttons
blink twice (approximately 2 seconds).
C O N T R O L
PRESET ENTER ESC VIEW
C O N T R O L
PRESET ENTER ESC VIEW
Press and hold the Enter and
Esc buttons simultaneously to
toggle executive mode on or off.
2 seconds
The Preset and View buttons
blink twice to indicate the
mode change.
Release the buttons.