Extron Electronics DMS 1600_2000_3200_3600 Setup Guide - Manual (Page 22)

32 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Maintenance and Modifications 33 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Maintenance and Modifications
3. Slide the power supply out of the chassis.
4. Orient the power supply module to be installed with the LED to the
right.
5. Align the flanges on the power supply module with the left and right
power supply guides.
6. Gently slide the power supply module into the enclosure until the
power supply meets resistance.
7. Gently seat the power supply in the backplane.
8. Use a screwdriver to tighten the left and right knurled knobs to lock
the power supply in place.
Removing and Installing a Fan (DMS 1600 and DMS 3600)
The DMS 1600 has a single fan module. The DMS 3600 has two
identical fan modules. If a fan fails, it should be replaced at the earliest
opportunity.
The fan modules are hot-swappable; you do not need to power down the
switcher to install or remove either fan.
NOTE: DMS 2000 and DMS 3200 — The fans are fixed in place
and are not field replaceable.
1. Remove and retain the two screws that secure the row identification
plate (identifying the rows of the adjacent DVI input and output
connectors) to the fan. Retain the plate.
2. Rotate the top and bottom knurled knobs to completely loosen the
captive screws (see figure 16).
Align the fan
module edges with
the plastic guides.
RESE
T
REMOTE RS-232/RS-422
LAN
BI-LEVEL
TRI-LEVEL
ACT LINK
100-240V 50/60Hz 1.2A MAX.
100-240V 50/60Hz 1.2A MAX.
REDUNDANT
PRIMAR
Y
DISCONNECT BOTH POWE
R
CORDS BEFORE SERVICIN
G
SWITCH REFERENCE
PRIMAR
Y POWER SUPPL
Y
REDUNDANT POWER SUPPL
Y
ANAHEIM, CA
1 - 8
9 - 16
17 - 24
25 - 32
Knurled
Knobs
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
A
B
DVI-D INPUTS
DVI-D OUTPUTS
DMS 44 DVI
C
D
A
B
C
D
Figure 16. Remove and Install a Fan
3. Gently pull on the screws to loosen the fan from the backplane.
4. Slide the fan out of the chassis.
5. Orient the fan to be installed so that the printing on the back of the
panel is right-side up.
6. Align the flanges on the fan with the top and bottom fan guides.
7. Gently slide the fan into the enclosure until the fan meets resistance.
8. Gently seat the fan in the backplane.
9. Use a screwdriver to tighten the top and bottom knurled knobs to
lock the fan in place.
10. Secure the row identification plate to the fan.