Extron Electronics DMS 1600_2000_3200_3600 Setup Guide - Manual (Page 9)

DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Front Panel Operations 11 10 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Installation
Front Panel Operations
This section describes simple DMS matrix switcher operation from the
front panel. Topics that are covered include:
• Creating a Tie
• Viewing Ties (and Muting Outputs)
• Saving or Recalling a Preset
• Locking Out the Front Panel (Executive Mode)
Creating a Tie
A "tie" is an input-to-output connection.
A "set of ties" is an input tied to two or more outputs. (An output can
never be tied to more than one input.)
A "configuration" is one or more ties, one or more sets of ties, or a
combination.
1. Press and release the Esc button to clear any input button, output
button, or control button indicators that may be lit.
2. Press and release the desired input button.
5
The button lights to indicate the selection.
3. Press and release the desired output buttons.
3 4 ENTER 8
The output buttons blink to indicate the potential ties.
The Enter button blinks to indicate
the need to confirm the change.
4. Press and release the Enter button. All button indicators turn off.
Viewing Ties (and Muting Outputs)
1. Press the View button. Output buttons light for outputs that have no
ties established.
NOTE: If an output button blinks, that output is muted. To
toggle mute on and off, press and hold the output button for 2
seconds.
2. Press an input button. The buttons for all tied outputs light.