Installing and starting the control program, Installing the program, Command and response – Extron Electronics DMS 1600_2000_3200_3600 Setup Guide User Manual
Page 16: Table for ip-specific sis commands, Installing and starting the, Control program
21
DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Control
Installing and Starting the Control Program
Another way to operate the switcher is via the Windows
®
-based Matrix
Switchers Control Program. This program is contained on the Extron
Software Products DVD (included with the switcher) or on the website.
Run this program on a PC connected to a serial port (
item
e
on page 8),
Ethernet port (
item
f
on page 8), or USB port (
item
a
on page 9) on the
switcher. The program must be installed on a Windows-based computer
and cannot be run from the DVD.
NOTE: For details on operating the program see the “Matrix
Software” section in the DMS Series Matrix Switchers User Guide.
Installing the Program
NOTE: To run this program while your computer is connected to
the Configuration (USB) port, use version 8.0 or newer of the Matrix
Switchers Control Program.
1.
Insert the DVD into the drive. The Extron software DVD window
should appear automatically.
Figure 9.
Software DVD Window
NOTE: If the window does not open automatically, run
Launch.exe from the DVD.
2.
Click the Software tab.
3.
Scroll to the Matrix Switchers program and click Install.
Figure 10.
Select Matrix Switchers Program