Extron Electronics DMS 1600_2000_3200_3600 Setup Guide - Manual (Page 6)

DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Installation 5 4 DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Introduction
Installation
This section describes installation of the DMS matrix switchers, including
connections and features. Topics that are covered include:
• Rear Panel
• Front Panel
Rear Panel
I/O Board Configuration Overview
See figure 2. Each I/O board is identified by the input and output
connector numbers supported by the board position. The input and
output numbers on the boards are identified as locations A through D.
ANAHEIM, CA
100-240V 50/60Hz 1.2A MAX. PRIMARY POWER SUPPLY
1 - 4
5 - 8
9 - 12
13 - 16
DVI-D INPUTS
A B
DVI-D INPUTS DV
C D
A B C D
A B
A B
TMDS
FIBER
INPUTS
C D
Slot 1
(1-4)
Input 1
Slot 2
(5-8)
Slot 3
(9-12)
Slot 4
No board
installed
Output 1 Input 3 Input 4 Input 2 Output 2
Input 5 Input 6 Input 7 Input 8
Location A
Input
Location A
Output
Figure 2. Arrangement of Inputs and Outputs on the I/O boards
The board position designators correspond to the input and output
numbers served by that position (1 through 4, 5 through 8, and so on).
The location designators, A through D, correspond to the DVI input or
output, grouped with inputs on the left and outputs on the right and
numbered from left to right.
The input numbers supported by the I/O board in slot 2 (locations
5 through 8) are as follows: A = 5, B = 6, C = 7, D = 8.