Extron Electronics DMS 1600_2000_3200_3600 Setup Guide - Manual (Page 12)

15
DMS 1600, DMS 2000, DMS 3200, DMS 3600 • Remote Contr
ol
Command and Response Table for SIS Commands
Command ASCII Command
(Host to Unit)
Response
(Unit to Host)
Additional Description
NOTES:
• Commands can be entered back-to-back in a string, with no spaces. For example: 1*1!02*02&003*003%.
• The matrix switchers support 1-, 2-, and 3-digit numeric entries ( 1*1!, 02*02&, or 003*003%).
Create ties
NOTES:
• The ! tie command, the & tie command, and the % tie command can be used interchangeably.
• The ! read tie command, & read tie command, and the % read tie command can be used interchangeably.
Tie input
X! to output X@ X! * X@ ! Out X@ • In X! • All ] Tie input X! to output X@ .
Example (see Notes, above): 1*3! Out03 • In01 • All ] Tie input 1 to output 3.
Tie input
X! to output X@ X! * X@ & Out X@
• In X!
• RGB ] Tie input X! to output X@ .
Example (see Notes, above): 10*4& Out04 • In10 • RGB ] Tie input 10 to output 4.
Tie input X! to output X@ X! * X@ % Out X@ • In X! • Vid ] Tie input X! to output X@ .
Example (see Notes, above): 7*5% Out05 • In07 • Vid ] Tie input 7 to output 5.
Read output tie X@ & X!] Input X! is tied to output X@ .
Read output tie X@ % X!] Input X! is tied to output X@ .
Read output tie X@ ! X!] Input X! is tied to output X@ .
NOTE: • = Space
X!
= Input number 00 – maximum number of inputs for your configuration (00 = untied)
X@
= Output number 01 – maximum number of outputs for your configuration