Extron Electronics FOX Matrix 14400 User Guide - Manual (Page 46)

4. Proceed to “Starting the Program,” below, or return to the Command and Response
Table in
Programming Guide , beginning on page 25.
NOTE: You may need to repeat these steps if you subsequently connect the
switcher to a different USB port on the same computer.
Starting the Program
1. To run the Matrix Switchers Control Program, click
Start > Programs > Extron Electronics > Matrix Switchers >
MATRIX Switcher + Control Pgm .
The Comm Port Selection window appears (see figure 16).
Figure 16. Comm Port Selection Window
2. Choose either the comm port that is connected to one of the serial ports of the
switcher,
IP [LAN] , or Emulate .
• If you selected a comm port, check the baud rate displayed in the comm port
selection dialog box.
NOTE: If you need to change the baud rate, click the Baud
button and double-click the desired baud rate. The default
is
9600 .
Click OK . The Extron Matrix Switchers Control Program window appears, displaying
the current configuration of the attached matrix (see figure 18 and figure 19 on
page 42). Proceed to step 4.
• If you selected IP [LAN] , click OK and proceed to step 3.
• If you selected Emulate , click OK and see Using Emulation Mode on page 56.
FOX Matrix 320x and FOX Matrix 14400 • Matrix Software 40