Rear panel features and connections, Power connections, Figure 6. ipcp 505 rear panel – Extron Electronics IPCP 505 User Guide User Manual
Page 17: Figure 7. switched power output ports
IPCP 505 • Hardware Features and Installation
11
Rear Panel Features and Connections
FLEX I/O
LAN
1 2 3 4 G
COM1
TX RX G
G
G
G
IR/SERIAL
RELAY
5
S G S G
6
1
S G S G
2
3
S G S G
4
7
S G S G
8
5
6
1
2
3
4
7
8
COM2
TX RX
TX RX G
G
TX RX
COM3
TX RX
G
TX RX
COM7
COM4
CTS
COM5
COM6
COM8
TX RX
5A MAX
100-240V 50-60Hz
MAC:
00-05-A6-XX-XX-XX
S/N:
RTS
G
CTS
TX RX
RTS
SWITCHED 12VDC
40W MAX TOTAL
+ - + -
+ - + -
1
2
3
4
Rear Panel
6
MAC
address
Figure 6.
IPCP 505 Rear Panel
Power Connections
a
Power input connector — Connect the IPCP to a 100-240 VAC power source here.
b
Switched 12 VDC power output ports — These four ports provide 12 VDC output
up to a combined maximum of 40 watts. Once configured, each port can be separately
turned on or off. These ports are monitored continuously for total power usage (draw).
R
SWITCHED
12VDC
3
1
4
OVER
2 LIMIT
IPCP 505
5A MAX
100-240V 50-60Hz
SWITCHED 12VDC
40W MAX TOTAL
+ - + -
+ - + -
1
2
3
4
Lights if total power draw is
40-44 watts.
Lights if total power draw
exceeds
44 watts.
Power output shuts off.
The user must turn these
ports back on.
Switched 12 VDC
Power Output
• 12 VDC, 40 watts (max.)
= total output for all four ports
combined
• Corresponding front panel
green LEDs ( ) light when
power is available at each port.
Tie Wrap
3/16"
(5 mm)
Max.
Power Input
• Front panel LED lights when
the IPCP receives power.
• Connect to 100 to
240 VAC.
Rear Panel
Front Panel
Figure 7.
Switched Power Output Ports
•
When the total power usage exceeds a threshold of 40 watts but is still below
44 watts, the IPCP enters the
limit mode, during which the yellow front panel
Limit LED lights. If you have configured the unit to do so, the IPCP can issue a power
overcurrent notice.
•
If power usage exceeds a second, higher threshold (44 watts), the IPCP enters
overcurrent mode. It turns these ports off, and the red front panel Over LED lights.
If the ports are disabled, the user must disconnect or fix the attached devices to
correct the problem, after which power output can be re-enabled via controls in the
IPCP internal web pages or via an SIS command.
(page
)