Remapping port designations, Sis commands – Extron Electronics IPCP 505 User Guide User Manual
Page 74
IPCP 505 • SIS Pr
ogramming and Contr
ol
68
Command/Response Table for SIS Commands (continued)
Command
ASCII (Telnet)
(host to IPCP)
URL Encoded (web)
(host to IPCP)
Response
(IPCP to host)
Additional description
Remapping port designations
For security reasons the network administrator may wish to assign new/different port numbers to the Telnet, web browser, and direct access ports of the controller or to disable
one or more ports. Typically Telnet uses port 23, web access is via port 80 (HTTP), and direct access is via port 2001.
ATTENTION: Do
not set two or more ports to the same port number. Setting two ports to the same number could cause networking conflicts and will also result in an E13
(invalid parameter) error.
NOTE: If you remap a port, you must set the port number to 1024 or higher, unless you reset the port to the default number or disable the port by setting it to
0.
Set the Telnet port map
24
E
port#MT
}
Wport# MT
|
Pmt port#
]
Select a number (port#) for the port that will
not conflict with any other ports.
Reset the Telnet port map
24
E
23MT
}
W23MT
|
Pmt 00023
]
This resets the Telnet port to port 23.
Disable the Telnet port map
24
E
0MT
}
W0MT
|
Pmt 00000
]
Setting the port number to 0 disables the
port.
Read the Telnet port map
E
MT
}
WMT
|
port#
]
If set to the default port number, the response
is 00023.
Set the web (HTTP) port map
24
E
port# MH
}
Wport# MH
|
Pmh port#
]
Reset the web (HTTP) port map
24
E
80MH
}
W80MH
|
Pmh 00080
]
This resets the web port to port 80.
Disable the web (HTTP) port
24
E
0MH
}
W0MH
|
Pmh 00000
]
Read the web (HTTP) port map
E
MH
}
WMH
|
port#
]
Set the initial port number for the
direct access port map
24
E
port# MD
}
Wport# MD
|
Pmd port#
]
This command sets the initial (lowest) port
number for the range numbers assigned to
the serial ports for direct port access (see
page 12 for
for more on
). By default the
IPCP direct access port numbers start at
2001 (for COM1) and go up to 2016 (for
IR/serial port 8).
Reset the direct access port map
24
E
2001MD
}
W2001MD
|
Pmd 02001
]
This resets the initial direct access port to
port 2001.
Disable the direct access ports
24
E
0MD
}
W0MD
|
Pmd 00000
]
Read the direct access port map
E
MD
}
WMD
|
port#
]