Unidirectional control and communication, Connections, Ir/serial – Extron Electronics IPCP 505 User Guide User Manual
Page 20: Output, Ports

IPCP 505 • Hardware Features and Installation
14
Unidirectional Control and Communication Connections
g
IR/Serial output ports — An IPCP 505 can use infrared signals or unidirectional
RS-232 serial signals to control various devices (up to 32 total for IR) via these eight
ports. Set output signal type (IR or serial) during configuration. The figure below shows
wiring examples.
6
7
8
IR/S
TX
RX
RTS
CTS
5
1
6
2
7
3
8
4
RELAY
5
1
6
2
7
3
G
IR/SERIAL
5
S G S G
6
1
S G S G
2
3
S G S G
4
7
S G S G
8
CO
OM7
CTS
S
COM8
TX
RX
RX
RTS
G
CTS
TX
RX
RTS
Rear Panel
Front Panel
S
G
(-)
(+)
(-)
(+)
(+)
(-)
To the IR
Receiver of a
Projector,
Display, or
Source Device
Two Single IR Emitters
Ground
IR Output Signal
Unidirectional
IR
or
IR or RS-232
Output
Ground
Strip wires
3/16"
(5 mm)
max.
To Projector,
Panel Display, or
the Wired
IR Remote or
RS-232 Port of a
Source Device
IR/S LEDs
Light when signals are transmitted
on the corresponding IR/serial port
IR/Serial Ports
Output options:
• IR (with or without carrier signals)
• unidirectional RS-232
Figure 10.
Wiring the IR/Serial Ports
Serial control: Connect one of these ports to the serial control receive (Rx) and ground
pins of the device to be controlled. These ports have the same serial protocol options
as the COM ports.
IR control: Connect one of these ports directly to the wired IR port of another device.
Or insert the wires from up to four IR Emitters into an IR port and place the heads of the
emitters over or next to the IR signal pickup windows of the devices. For wiring, see the
following figures or the IR Emitter Installation Guide.
NOTE: Each emitter must be within 100 feet of the IPCP for best IR control results.
Installing One Single Emitter Installing One Dual Emitter
Ground (−)
IR Signal (+)
One Single IR Emitter
Ground (−)
IR Signal (+)
Dual IR Emitter
Installing Two Single Emitters
When installing only single emitters, tie them in series as shown below.
(+)
(−)
(−)
(+)
IR Signal (+)
Ground (−)
Two Single IR Emitters