Extron Electronics MS9500 HD FrEND Plus - Manual (Page 74)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
Videobars <Channel list>
Turn on video color bar output for the requested channel.
The Player will respond with
OK or ERROR
Loopon <Channel list>
Enable the Auto repeat mode. This will cause the channel to loop (auto-repeat) at the end of the selected files in
the playlist.
The Player will respond with:
OK or ERROR
Loopoff <Channel list>
Turn off the loop flag for the requested channel.
The Player will respond with:
OK or ERROR
Timecode Commands
NOTE: This section applies to the MS9500GL only - the MS9500 does not accommodate Timecode.
Tcgenerate <Channel list> <timecode>
Turns the timecode generator on and sends the timecode hh:mm:ss:ff out as a jam sync.
The Player will respond with:
OK or ERROR
Tcreceive <Channel list>
Sets the player into timecode receive mode.
The Player will respond with:
OK or ERROR
Tcreceiveloop <Channel list>
Sets the player into timecode receive mode and loop the input timecode to the output.
The Player will respond with:
OK or ERROR
Tcplayat <Channel list> <timecode>
Sets the timecode playat time
The Player will respond with:
OK or ERROR
70 Rev. 1.26