Extron Electronics MS9500 HD FrEND Plus - Manual (Page 79)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
Loadscene<Channel list><scene name> Adds specified scene to the player’s current playlist
Cuescene <Channel list> <scene name> Cues specified scene to the player
Playlist Commands
ClearPlaylist<string> Clears all entries from the Playlist identified by <string>
ListAllPlaylists Returns a list of all Playlists stored in the player
AddPlaylist<listname><medianame><0
><0> Adds a clip to a Playlist
LoadPlaylist<Channel list><string1> Loads a specific Playlist onto a specified channel
ListPlaylist<string1> Returns a list of clips contained in the identified Playlist
Playrange <channel list> <start
chapter> <end chapter> Sets the start and end chapters for a Playlist on the specified
channel. This command will also pre-load the start chapter in
preparation for the Playlist command
Adjustrange<Channel list><start
chapter><end chapter> Adjusts start and end chapters for current Playlist on the specified
channel.
Replace<Channel
list><source><destination> Replace a clip in a Playlist
Switchplaylist<Channel list><string> Perform a seamless switch to another playlist
Playback Commands
Play<Channel list> Play the currently loaded Playlist
Stop<Channel list> Stop the currently playling file and turns video output off
Pause<Channel list> Pauses currently playing file freezing frame on display
Seek<Channel list><frame number> Seek to a position in a file, specified as a frame number
Audioon<Channel list> Turn audio on for the requested channel
Audiooff<Channel list> Mute the audio for the requested channel
Videoon<Channel list> Turn on video for the requested channel
Videooff<Channel list> Turn off (“Mute”) video on the requested channel
Videobars<Channel list> Turn on video color bars on the requested channel
Loopon<Channel list> Enable loop mode for the specified channel
Loopoff<Channel list> Turn off the loop flag for the requested channel
Fastseek<Channel><start chapter><end
chapter> Seek to a new file in the playlist as quick as possible. Currently
playing content is frozen on the display while the fastseek
command cues the new playrange. This command should only be
used if all files in the playlist are the same format and should be
followed by a Play command.
Volume<channel list><right><left> Set the audio output level between 0 and 100 (inclusive; this is a
percentage of the maximum output level) for each side of the
stereo audio output. Right and Left channel must be the same.
System/Status Commands
Shutdown Shut the player system down
Reboot Reboot the player
75 Rev. 1.26