Extron Electronics MS9500 HD FrEND Plus - Manual (Page 76)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
Reboot
Reboot the HD Player.
The player doesn’t send a response to this command.
Getstate <Channel list>
Request the status of certain parameters for a specific player (Channel)
The Player will respond with:
Statetc 1 “00:00:00:00” (“current timecode”)
Statefile 1 “clip” “ (current clip”)
Stateplay 1 “status” (“playing”, “paused”, “stopped”)
Miscellaneous Commands – (Telnet Protocol)
Playfiles <Channel> <start chapter> <end chapter>
Load and play a range of files
Playlist <Channel>
Begins playback of the selected chapters. This command should normally follow a Playrange command.
Play <Channel>
Play the currently loaded file.
[When a file is playing the HD player will return this command:
Channel x Playing <cr> <lf> (where x is the base channel set in the channel properties) .]
[When a file has played the HD Player will return this command:
Channel x Playlist Complete <cr> <lf> (where x is the base channel set in the channel properties) .]
Note: The Play and Playlist commands are identical in the HD Player. Both are maintained for compatibility with
other Electrosonic Player products.
Add <Channel> <FileName>
Adds a file to the playlist of the requested channel.
Clear <Channel>
Clears all files from the playlist.
List <Channel>
Returns a list of the files loaded into the current playlist.
72 Rev. 1.26