Extron Electronics MS9500 HD FrEND Plus - Manual (Page 80)

MS9500GL HD FrEND Plus Chapter 12: Remote Control Protocols
GetState<channel list> Retrieve status information from the player. (Playing, Paused,
Transitioning…)
GetVersion<channel list> Retrieve version of HDPlayer application
GetDiskInfo Retrieve total disk space and free disk space in the D: partition of
the player
Timecode Commands
Tcgenerate<channel list>hh:mm:ss:ff Turns the Timecode Generator on and sends timecode
hh:mm:ss:ff as a jam sync
Tcreceive<channel list> Sets the player into timecode receive mode
Tcreceiveloop<channel list> Sets the player into timcode receive mode and loops input
timecode to output
Sets the player to start playing at time hh:mm:ss:ff Tcplayat<channel list>hh:mm:ss:ff
Tcstart<channel list> Starts the timecode running (assumes the player is in TC generate
mode)
GPIO Commands
Getinput Verify state of the GPIO Digital Inputs 1-4
GetOutput Verify state of the GPIO Changover Relay Outputs 1-4
SetOutput Set GPIO Changeover Relay Outputs 1-4 ‘On’ (+) or ‘Off’ (-)
76 Rev. 1.26