Extron Electronics MVP 104GX User Guide - Manual (Page 23)

MVP 104GX Operation 3-5
User presets
Before storing any presets, first optimize the window images by setting the
picture controls (contrast, brightness, tint, color), the sizing and positioning
(horizontal and vertical), and the blanking (top, bottom, left, right). See the
“Optimizing the Image” section.
The eight user Preset buttons save/recall eight preset user-defined window
output configurations, including window positioning, sizing, blanking,
priority, test, and audio input selection.
• To save the current window configuration, while in the Default Cycle
menu (see Default cycle menu section), press the Store button for three
seconds. The green LED above the store button lights and the amber
LED above or below each Preset
button flashes for 16 seconds. The
message “Select Location To Save”
also appears on the LCD panel
during those 16 seconds. During
this time, press a Preset button to
save the configuration. The amber
LED above or below the selected
user preset button lights and the
message “User Preset Saved” appears on the
LCD panel for 16 seconds. Wait until the
Default Cycle menu resumes before pressing any
other button.
• To recall a user preset, while in the Default Cycle
menu, select a user preset button. The preset’s LED lights
amber. Any configuration modification made to a selected
user preset turns the LED off.
• Above and below the Preset buttons are slots to attach labels which
identifies the preset configurations. The 8 user presets can also be
saved/recalled through RS-232/RS-422 commands. In addition to
these 8 user presets, 16 more user presets can be saved/recalled
through RS-232/RS-422 commands only. See the Programmer’s
Guide chapter.
Factory patterns
While the LCD panel is in the Default Cycle menu (see Default
cycle menu section), pressing the Factory Patterns button displays
the LCD message “Preset ## of 20 Menu= No Next=Yes”
where ## refers to the factory pattern preset from 01 to 20.
Rotating the Vertical sizing knob recalls the 20 factory
pattern preset window output configurations.
Pressing the Menu button rejects the configuration
(=No), and pressing the Next button accepts the
configuration (=Yes). Any factory pattern preset can
be conveniently stored as a user preset (see the
previous User presets section).
See figure 3-4 for an illustration of the 20 factory pattern presets.
FACTORY
PATTERNS
Preset ## of 20
Menu=No Next= Yes
Select Location
To Save
User Preset
Recalled
User Preset
Saved
PRESETS
P