Liberty Pumps Ascent II - Manual (Page 13)

©Copyright 2013 Liberty Pumps Inc. All rights reserved. 13
disconnect this cord. See instructions under the heading “Accessibility to Motorized cartridge 4-3-5” for details.
4-3-9 Toilet sealing ring:
The seal between the toilet and the macerator consists of a rubber ring connected to the macerator to which the toilet
slides into. The rubber ring stretches and forms a seal around the discharge hub of the toilet. This rubber ring is
replaceable by unclipping the plastic retainer and then pulling the ring outward. Installation is reverse, first slide the rubber
ring onto the macerator followed by the retaining ring.
5-1 BEFORE REFERRING TO TROUBLESHOOTING CHART
5-1-1 Check plumbing system. Flush toilet and ensure water supply is turned on.
5-1-2 Check electrical system. Ensure breaker and receptacle GFCI are on. Check condition of circuit breaker
or fuse. Ensure plug is not loose. If the pumping unit’s thermal overload has activated, it will take about 20
minutes to reactivate.
5-1-3 Ensure decorative covers are installed and fully seated such that safety switch is activated. The green
light should be solid green if safety switch is properly activated.
5-1-4 Check the hydraulic system. Check that the discharge pipe and vent pipe are not blocked.
5-1-5 If the macerating pump turns on intermittently without flushing the toilet or collecting water drainage from
sink, shower, or tub, check for leakage from the toilet tank flush valve.
5. Troubleshooting