Franklin Fueling Systems T5 Series Fuel Management System Programming Guide - Manual (Page 10)

6
Password Login
1. Press the User Roll icon
2. Enter Password for the desired level as described in the Access Control section on page 5.
Default passwords are as follows:
Guest: guest
User: user
Administrator: admin
Tapping twice on the User Role Icon will reset to guest level access.
Modifying Passwords
For initial settings and continuous security purposes, the console will allow you to change any password used for
accessing console functions. When changing passwords, make note of the password and keep it in a secure, memorable
place. The password you choose must be at least two characters long with a maximum of 16 characters — spaces and
special characters are allowed as part of your password.
The Administrator status is required to change passwords.
From the touch screen display, changing access passwords is done by navigating through menus to modify a password.
1. When the console is powered up, press the Main Menu button .
2. Press the Configuration Application button.
3. Press Passwords in the application window, and then press the corresponding button to change the password for that
access level.
4. Verify the correct password has been entered, and then press the Checkmark button.
Connecting a PC or Laptop Computer
To access the console using the Web Browser interface, connect a PC to the console through either the Ethernet port or
the COMM 1 serial port. If the console is connected to a local network, you can perform this setup from any PC on that
network by using a web browser application, such as Microsoft’s Internet Explorer or Mozilla’s FireFox (the console’s IP
address may need to be modified — see Configuration in Section 2).
The following instructions are written specifically for Microsoft’s Windows XP operating system. For assistance with other
operating systems, please contact Franklin Fueling Systems Technical Services.
Connecting a PC to the T5 series Ethernet Port
1. Using an Ethernet Crossover, 10 Base-T cable, plug the RJ-45 connector on one end of the cable into the Ethernet
port of the console.
2. Plug the RJ-45 connector on the opposite end of the cable to the Network Interface Card of the computer.
3. Verify that the green POWER LED on the front panel of the console is lit, which indicates that the console has power.
4. Power up and log onto your PC.
Note: You may need to reconfigure your TCP / IP settings to allow the computer to communicate with the console.