Franklin Fueling Systems TSSP-TMPTR Thermal Printer - Manual (Page 3)

3
Figure 4: Install Stand-offs
11. Mount the printer so that the clear printer cover
faces outward of the front door.
Figure 5: Mount Printer in Door
12. Attach the 6 screws for the thermal printer board to
the front door (Figure 6). Refer to the screw chart
on the previous page.
Cable Connected
Foam Pad
Figure 6: Printer Circuit Board Installed
13. Connect the cable from the thermal printer board
to the interface board of the front door (Figure 6).
14. Tighten the two screws that hold the plastic bezel
by inserting a screwdriver through the access
holes in the circuit board.
15. Check to make sure the foam pad covers the corner
of the circuit board where the power cables connect.
16. Replace the metal inside cover plate on the front
door and fasten the screws. Make sure to reattach
the ground connector to the plate.
17. Lift up on the green panel to open the printer and
load paper (Figures 7-9). Make sure the roll is
oriented as shown.
Figure 7: Load Paper
Figure 8: Do NOT load paper from door, Do NOT have paper
wound loosely
Figure 9: Paper Loaded Correctly
18. Close the printer door.
19. Restore power to the tank gauge.
Plastic Bezel
Paper Specifications
Type: Thermal Printer Paper
Width: 58 mm (2.28")
FFS part #: TS-TP2 (box of 5 rolls)
TS-TP2C (Carton of 20 boxes = 100 rolls)