Aeromotive 18670 - A1000 CORVETTE STEALTH KIT - Manual (Page 2)

The following steps are typical of most installations:
1. Disconnect the negative battery cable and drain the fuel tanks.
2. Raise and support the vehicle.
3. Remove the right rear tire and wheelhouse panel.
4. Disconnect the fuel pump module harness connector.
5. Remove the crossover tube from the clamp located above the transmission. FIGURE 1-1
FIGURE 1-1
6. Removal of the driveline and exhaust may be necessary to remove the crossover tube. Once you have performed this
procedure, you will gain enough knowledge of the components that you may be able to do the procedure in the future
without lowering the driveline. You must slide the CPA ring aside so the collar can be turned counter clockwise.
FIGURE 1-2
FIGURE 1-2