Alpha Technologies CFR 3000, CFR 3000RM - Manual (Page 20)

2 Installation 14
2.2 Installing the Unit (Continued)
5 If the brackets are not needed, remove the cover and the front panel as described in Sec-
tion 5.4, Step 1, “Remove the Front Panel and the Cover.”
DANGER:
1) There are dangerous voltages inside the unit when the cover is removed.
2) When removing or attaching the cover, do not let it touch the battery terminals, battery
wires or other internal components.
7 Reattach the cover and the front panel.
8 To stop the unit from moving, screw down the feet until they are solid against the floor.
Installation finished
2.2.2: CFR 3000RM
Tip: The unit is shipped so that it will fit in a 19 inch rack. To fit in a 23 inch rack, reverse the
position of the mounting brackets.
Procedure:
1 The unit is shipped attached to a pallet. Use a forklift to transport the unit and pallet to the
installation site.
2 Remove the packing from around the unit. Unbolt the unit from the pallet.
3 Move the unit to the rack.
4 Mount it in the rack. The mounting screws are not provided by Alpha. Use the screws speci-
fied for your rack.
5 Mount an Alpha external battery pack (Section 2.4).
Installation finished
6 Remove the seismic brackets by unbolting the four
bolts attaching them to the unit.