Alpha Technologies INVERTER 2000 - Manual (Page 16)

Alpha Technologies Ltd. 014-129-B2 Rev C WC
© 2010 Alpha Technologies Ltd. ALPHA is a registered trademark of Alpha Technologies Ltd. All Rights Reserved. Page 10 of 19
Once the module is ON use this switch to stop unit remotely.
Restart method: close the remote switch - unit will auto restart.
Remote switch is available when power ON/OFF switch is at ON position.
4.3 Pre-Operation Check
Inverter Operation Check
•
Check if the DC input polarity is connected correspondingly.
• Ensure the input voltage is in the standard range.
• Check corrected connecting wiring size based on the wiring table.
• Check if the ground wiring is connected on rear cover for safety, avoiding electrical shock.
• The breakers are at ON position.
• To operate the Auto Transfer Switch it is necessary to make sure that the nominal voltage and frequency of
the grid match the corresponding settings of the unit.
Verify that the nominal frequency and voltage values are equal to those of the grid.
4.4 Status Monitoring
When the inverter is properly installed with power on, the LCD screen would light by displaying “Waiting” for self-
diagnosis. Few seconds after, general status is shown as follows.
Waiting ...
1.INV: xxx.xV
2.ACV: xxx.xV
3.OPV: xxx.xV
4.Priority: BAT.
Figure 9–Power start page
Press “Enter ” key, “Main Menu” will be shown as follow, “STATUS” and “SETTINGS” menu can be selected
via pressing “PgDn ”or “PgUp ” and “Enter ” key.
Figure 10–Main menu
Heading Value
Address Inverter module location
OPV Output voltage of the inverter module in Volts (V)
OPI Output current of the inverter module in Amperes (A)
OPF Output frequency of the inverter module in Hertz (Hz)
OPP Power capacity of the inverter module in Volt-Amperes (VA)
Input Volt DC input voltage of the inverter in Volts (V)
Power Used Load level in percentage (%)
Ambient Temp. Inverter ambient temperature (ºC)
Power Limited Power limited in percentage (%)
Mains AC Volt Voltage of Mains AC
Mains AC Freq Frequency of Mains AC
Priority On-line/Off-line
Table B–LCD display of inverter status