B&K Precision 9116 - Programming Manual - Manual (Page 10)

STATus:QUEStionable:CONDition?
This command is used to read the value of query condition register. When a bit of QUES
condition changes, the bit value corresponding in QUEST event register is 1.
Query syntax：STATus:QUEStionable: CONDition?
Parameter: None
Returned parameter: <NR2>
STATus:QUEStionable:ENABle
This command can set the parameter of quest event enable register. Setting parameter can
determine which bit value of quest event register is 1 and the bit will enable QUES.
Command syntax：STATus:QUEStionable:ENABle <NR2>
Parameter: 0~65535
Default set: Refer to *PSC command
Example: STATus:QUEStionable:ENABle 128
Query syntax: STATus:QUEStionable:ENABle?
Returned parameter: <NR2>
STATus: QUEStionable:NTRansition
This command is used to edit the negative transition trigger register of operation event. The
parameter determines which bits of operation event register is 1 and will change the OPER of
status byte register to be 1.
Command syntax: STATus: QUEStionable:NTRansition <NR1>
Parameter: 0~255
Example: STATus: QUEStionable:NTRansition 128
Query syntax: STATus: QUEStionable:NTRansition?
STATus: QUEStionable:PTRansition
This command is used to edit the positive transition trigger register of operation event. The
parameter determines which bits of operation event register is 1 and will change the OPER of
status byte register to be 1.
Command syntax: STATus: QUEStionable:PTRansition <NR1>
Parameter: 0~255
Example: STATus: QUEStionable:PTRansition 128
Query syntax: STATus: QUEStionable:PTRansition?
STATus:OPERation[:EVENt]?
This command can read the parameter from operation event register. After executing this order,
operation event register is reset.
Query syntax: STATus:OPERation [:EVENt]?
Parameter: None
Returned parameter: <NR1>
Relative command: STATus: OPERation:ENABle
Bit definition of operation event register: