B&K Precision 9116 - Programming Manual - Manual (Page 14)

Command syntax: SYSTem:RWLock
Parameter: None
SYSTem:POSetup
This command configures the power on state of the instrument.
Command syntax: SYSTem:POSetup RST|SAV0
Parameter: RST|SAV0
Returned parameter: None
Query syntax: SYSTem:POSetup?
SYSTem:POSetup?
Command syntax: SYSTem:POSetup?
Parameter: None
Returned parameter: RST|SAV0
SYSTem:CLEar
This command is used to clear the error codes and information.
Command syntax: SYSTem:CLEar
Parameter: None
Returned parameter: None
SYSTem:BEEPer
This command is used to enable or disable the beeper.
Command syntax: SYSTem:BEEPer
Command syntax: SYSTem:BEEPer<bool>
Parameters: 0|1|ON|OFF
Query syntax: SYSTem:BEEPer?
Returned value 0 corresponds to the off state of beeper.
Returned value 1 corresponding to the on state of beeper.
Return parameters:0|1
SYSTem:COMMunicate:GPIB:RDEVice:ADDRess
This command is used to set the GPIB address.
Command syntax：SYSTem:COMMunicate:GPIB:RDEVice:ADDRess <NR1>
Paramters: 0-31
inquiry syntax: SYSTem:COMMunicate:GPIB:RDEVice:ADDRess?
Return parameters: <NR1>
SYSTem:INTerface
This command is used to select the communication interfaces.
Command syntax：SYSTem:INTerface <GPIB|USB|RS232 |RS485>
ADDRess