B&K Precision 9116 - Programming Manual - Manual (Page 20)

2.7 LIST AND SEQUENCE Commands
LIST Commands
LIST:STATe
This command is used to set the state of list mode.
Command syntax: LIST:STATe <0|1|ON|OFF>
Query syntax: LIST:STATe?
Return parameter: 0|1
LIST:RECall
This command is used to recall a list file.
Command syntax: LIST:RECall <NR1>
Parameter: 1~10
Query syntax: LIST:RECall?
Return parameter: 1~10
LIST:EDIT
This command is used to select which list file to edit.
Command syntax: LIST:EDIT <NR1>
Parameter: 1~10
Query syntax: LIST:EDIT?
Return parameter: 1~10
LIST:POWer
This command is used to edit the power limit of the list file.
Comman syntax：LIST:POWer <NRf>
Parameter: MIN~MAX
Query syntax: LIST:POWer?
Return parameter: MIN~MAX
LIST:REPeat
This command is used to edit the number of repeat times of the list file.
Command syntax：LIST:REPeat <NR2>
Parameter: 1~65535
Query syntax: LIST:REPeat?
Return parameter: 1~65535
LIST:LINK:SEQuence
This command is used to edit the list sequence to be linked.
Command syntax: LIST:LINK:SEQuence <NR2>
Parameter: 0~1023