B&K Precision 9116 - Programming Manual - Manual (Page 13)

(4) Eeprom failure
(5) RST checksum failed
(10) RAM selftest failed
(40) Flash write failed
(41) Flash erase failed
(213) RS-232 buffer overrun
(216) RS-232 receiver framing
(217) RS-232 receiver parity
(218) RS-232 receiver overrun
(220) Front panel uart overrun
(221) Front panel uart framing
(222) Front panel uart parity
(223) Front panel buffer overrun
(224) Front panel timeout
(225) Front Crc Check error
(226) Front Cmd Error
(401) CAL switch prevents
(402) CAL password is incorrect
(403) CAL not enabled
(404) readback cal are incorrect
(405) programming cal are incorrect
(406) Incorrect sequence of cal
(600) FETCH of data was not acquired
(601) Measurement overrange
SYSTem:VERSion?
This command is used to query the current SCPI version. The returned parameter is a string
like”YYYY.V”, in which the YYYY is the year of that version, V is the software version of that year.
Command syntax: SYST:VERS?
Parameter: None
Returned parameter: <NRf>
SYSTem:REMote
This command is used to switch to the remote control mode (PC control).
Parameter: None
SYSTem:LOCal
This command is used to switch the instrument to local control mode (front panel control).
Command syntax: SYST:LOCal
Parameter: None
SYSTem:RWLock
This command is the same function as SYSTem:REMote, except this command can lock “LOCAL”
button as well. When this command is executed, the “Local” button will be disabled.