B&K Precision MDL Series - Programming Manual - Manual (Page 67)

67
This command is used to set series resistance when the load is in CZ mode.
Command Syntax [SOURce:]IMPedance:RESistance <NRf+>
Parameters 0 through 7500 ohms
Unit R (ohms)
*RST Value 0
Examples IMP:RES 5
Query Syntax [SOURce:]IMPedance:RESistance?
Returned Parameters <NR3>
[SOURce:]IMPedance:INDuction
Channel Specific
This command is used to set the series inductance when the load is in CZ mode.
Command Syntax [SOURce:]IMPedance:INDuction <NRf+>
Parameters 0 through 65000uH
Unit uH
*RST Value 0
Examples IMP:IND 5
Query Syntax [SOURce:]IMPedance:INDuction?
Returned Parameters <NR3>
[SOURce:]IMPedance:CAPacitance
Channel Specific
This command is used to set the parallel capacitance value when the load is in CZ mode.
Command Syntax [SOURce:]IMPedance:CAPacitance <NRf+>
Parameters 20 through 65000uF
Unit uF
Examples IMP:CAP 5
Query Syntax [SOURce:]IMPedance:CAPacitance?
Returned Parameters <NR3>
[SOURce:]IMPedance:HIGH
[SOURce:]IMPedance:LOW
This command is used to set the high and low voltage determined when the load is in CZ mode.