Chapter 4, Programming examples, 1 introduction – B&K Precision MDL Series - Programming Manual User Manual
Page 88
88
:SHORt <n>, <n>
Set the short channel for the selected seq.
N
:SHORt? <n>
Query the short channel for the selected seq.
N
:ONTime <n>,<NRf>
Set the on time for the selected seq.
N
:ONTime?<n>
Query the on times for the selected seq.
N
:OFFTime <n>,<NRf>
Set the off times for the selected seq.
N
:OFFTime? <n>
Query the off times for the selected seq.
N
:PFDTime <n>,<NRf>
Set the pass/fail delay time
N
:PFDTime? <n>
Query the pass/fail delay time
N
:PAUSe <n>
Set the pause sequence.
N
:PAUSe?
Query the pause sequence.
N
:STOP
:CONDition <cond>
Set the stop condition for test.
N
:CONDition?
Query the stop condition for test.
N
:CHAin <n>
Set the chain file for this program file.
N
:CHAin?
Query the chain for this program file.
N
:SAVe <n>
Save this program file.
N
:RCL <n>
Recall this program file.
N
Notes:
1.
Commands in the STATus subsystem are not affected by *RST and :SYSTem:PRESet. The effects of
cycling power, *CLS and :STATus:PRESet are explained by the following notes.
2.
Event Registers: Power-up and *CLS clears all bits of the registers. :STATus:PRESet has no effect.
3.
Enable Registers: Power-up and :STATus:PRESet clears all bits of the registers. *CLS has no effect.
Chapter 4
Programming Examples
4.1 Introduction
This chapter contains examples on how to program your electronic load. Simple examples show you
how to program:
•
Input functions such as voltage, current, and resistance