MoTeC C185 - Manual (Page 77)

72 Appendices MoTeC
To configure the PC with a fixed IP address:
1. Click Start | Settings | Control Panel
2. Double click on Network Connections
3. Double click on the connection that is used to connect to the C185,
usually Local Area Connection
4. Click Properties
5. Select Internet Protocol (TCP/IP) from the list
6. Click Properties
7. Select Use the following IP address
8. Enter the IP address and Subnet mask shown below.
Network Connection
The C185 can also be connected to a network rather than directly to a single
PC. This allows any PC on the network to communicate with the C185.
The connection time to the C185 will be less than 3 seconds (if the C185 is
already powered and running)
Note: The PC network settings should not be changed.