Climax CM6000 OBS CIRCULAR MILL - Manual (Page 2)

Specifications Specifications
Climax Portable Machine Tools, Inc. 2712 E. Second Street, Newberg, OR 97132 USA Web site: www.cpmt.com
Worldwide Phone: 1.503.538.2185 N. America Toll-Free: 1.800.333.8311 Fax: 1.503.538.7600 E-mail: [email protected]
page 2
Specifications
US Metric
Machine Performance
ID Mounting Range 78.5 - 178.5 inches 1993.9 - 4533.9 mm
Milling Diameter Range 78.5 - 197 inches* 1993.9 - 5003.8 mm|
* using 8 inch (203.2 mm) cutter
Flatness Tolerance
0.0004 inches/foot +/- 0.032 mm/m
Specified to 168 inches (4267.2 mm).
Capable flatness = 0.0004 * Radius of Flange, where Radius is in feet.
(Final tolerance obtained is dependant on setup and operating conditions)
Rotational Feed
Drive type Internal ring gear with in-line gear reducer
Rotational drive motor Electric Servo
Electric power, input options 230V; 380V; 415V; 460V; 575V
Servo feed motor power 1.5 kW
Table speed range 0.0005 rpm - 0.85 rpm
(0.30 inches/minute (7.62 mm/minute
at maximum diameter) at maximum diameter)
Milling Spindle
Drive type Overdrive gear
Spindle power
HPU @ 20 gpm, Max 25 Hp @ 75.7 l/min, max 18.7 kW
Effective, at spindle 15 Hp 11.2 kW
Gearbox ratio 1:1.259
Tool Holder #50 taper NMTB
Radial Travel per Setup 24 inches 609.6 mm
Spindle Travel (stroke z-axis) 8 inches 203.2 mm
Turning Arm Swing Diameter
Minimum 135 inches 3429.0 mm
Maximum 208 inches 5283.2 mm
Measures
Machine weight, total (approximate) 8600 lbs 3900.9 kg
Shipping weight, estimated 14000 lbs 6350.3 kg
Shipping Dimensions, 1 container 8’ x 10’ x 20’ 2439 x 3048 x 6096 mm
Tooling recommendations
Face mills max rpm max depth of cut
4 inch (101.6 mm) diameter, positive-positive 382 0.060 inches (1.524 mm)
5 inch (127.0 mm) diameter, positive-positive 306 0.060 inches (1.524 mm)
6 inch (152.4 mm) diameter, positive-positive 255 0.050 inches (1.27 mm)
8 inch (203.2 mm) diameter, positive-positive 191 0.040 inches (1.016 mm)
10 inch (254.0 mm) diameter, positive-positive 153 0.035 inches (0.889 mm)
When using an aggressive feed rate, it is recommended that the spindle RPM be increased to reduce the chip load.
Depth of cut may vary depending on rigidity of setup.
Maximum metal removal rate 12 in3/minute 196.6 cm3/minute
Maximum metal removal rates in mild steel in excess of the rate shown above may cause the cutter to stall.
All dimensions should be considered reference. Contact your Climax Representative for precision dimensions. Specifications are subject to change without notice. There are no systems or components on
this machine that are capable of producing hazardous EMC, UV or other radiation hazards. The machine does not use lasers nor does it create hazardous materials such as gasses or dust.