Climax FF5000 FLANGE FACER - Manual (Page 4)

Tool conFiguraTionS
Climax Portable Machining & Welding Systems Web site: climaxportable.com
Worldwide Phone:
1.503.538.2185 N. America Toll-Free: 1.800.333.8311 Fax: 1.503.538.7600 E-mail: [email protected]
page 4
Configure your FF5000 in 3 easy steps.
To configure your FF5000 Flange Facer:
1 Select a Base Unit
2 Select a Drive Option
3 Select a Mounting Option
To configure the Flange Facer you require, simply select the option
you need in each step, then contact your Climax representative.
The base unit includes the base assembly, alignment assembly,
interface assembly, standard compound tool head, a tool kit and
instruction manual.
1 Base Unit 49594
Includes primary machine, alignment assembly,
standard compound tool head, and tool kit
2 Drive Option 34450
Pneumatic motor assembly with air conditioner
3 Mounting Option
5 - 9 inch (127.0 - 228.6 mm) ID mounting chuck 29168
9 - 14 inch (228.6 - 355.6 mm) ID mounting chuck 29167
14 - 18 inch (355.6 - 457.2 mm) ID mounting chuck 29459
More than one mounting chuck may be selected.
By purchasing extra chuck/spindle interface and chuck assmeblies,
you can set up one flange while another is being machined,
significantly reducing downtime in an outage).
Accessories
3.5 - 5 inch (88.9 - 127.0 mm) ID mounting chuck 31627
Chuck spindle interface assembly 29559
Tooling Package 37809
Tool Kit
Tool Bits for Single Point Machining
1/2 x 4.0 inch (12.7 - 102 mm) LH Roughing
31868
1/2 x 4.0 inch (12.7 - 102 mm) LH & RH Finishing 25710
(ground on both ends)
Tools (inch size)
Hex wrench set, 0.050 - 3/8 inch
33999
End wrench, long, 7/8 inch 29173
End wrench, thin, 1-1/8 inch 14668
Crank Handle 29082
Standard configuration Downfeed on a flange edge
Cutting O-ring and seal groove Vertical flange facing