CEMB USA ER85 Installation Manual - Manual (Page 3)

ENGLISH
Installation manual Rev. 03-2012
3
INFORMATION
This warning indicates important information which must be carefully read.
2.3 DEFINITIONS OF “OPERATOR” AND “SPECIALISED TECHNICIAN”
Any professional person who is to access the machine for operation and routine maintenance is defined as an “op-
erator”. This means persons who have knowledge of the operating and maintenance procedures of the machine and
have the following qualifications:
training that authorises operation according to the safety standards in relation to the risks deriving from the pres 1.
ence of electrical power and moving devices and the risks related to manual load handling.
Trained to use the personal protection devices and basic fi rst aid training.
2.
The employer must assign a suitable person to operate the machine in accordance with the laws in force, assessing
his or her psycho-physical health, personal education, training and experience, as well as knowledge of the standards,
requirements and provisions for accident prevention.
In addition, the operator assigned based on the above must be specifically trained for use of the machine and any
accessories.
Finally, the operator must read through this manual.
2.4 PERSONAL PROTECTION DEVICES (PPD)
WARNING
D URING MACHINE INSTALLATION AND USE IT IS STRICTLY PROHIBITED TO OPERATE WITHOUT THE PROTECTION DEVICES DESCRIBED
IN THIS PARAGRAPH .
The persons that are to operate on and/or work in proximity of the machine may not wear clothes with wide sleeves,
laces, belts, bracelets or anything else that may pose a potential risk. Long hair must be tied up to prevent any risk.
2.4.1 Protection devices to wear
The following protection devices must be worn.
Insulated safety shoes with rubber sole
and reinforced tip
Use: always Protective gloves
Use: always
Goggles
Use: always Working clothes
Use: always
Safety rules