CEMB USA ER85 Installation Manual - Manual (Page 4)

ENGLISH
Installation manual Rev. 03-2012
4
2.5 GENERAL WARNINGS
CAUTION:
T HE MACHINE GENERATES , USES AND MAY IRRADIATE ENERGY AND RADIO FREQUENCY . I F NOT INSTALLED AND USED IN ACCORDANCE
WITH THE INSTRUCTIONS IN THIS MANUAL , IT MAY CAUSE INTERFERENCE WITH RADIO COMMUNICATIONS .
The machine must be installed, maintained and used according to the instructions given in this manual and ac- ▪
cording to the procedures given from case to case.
The employer must train the operators for safe installation, use and maintenance of the machine.
▪
Only specialised and specifically trained persons are to be allowed access to the machine for any extraordinary ▪
maintenance operation.
Before operating on the electrical parts of the machine cut the power.
▪
For the duration of maintenance, ▪ “Work in progress” signs must be posted in the department in such a way that
they are visible from all the access areas.
Always operate with due caution and wear the personal protection devices (PPD).
▪
The machine (and any accessory devices) must always be connected to earth to discharge short-circuit currents and ▪
electrostatic voltages. The mains voltage must correspond to the value shown on the machine identifi cation plate. It
is inadvisable to use cable extensions/socket adaptors. When the machine is not used, disconnect it from the mains
by pulling the plug from the socket.
Before carrying out any operation stop the machine.
▪
In the event of fire, do not use water but only powder or carbon dioxide fire extinguishers. ▪
It is strictly prohibited to deposit combustible material in the vicinity of the machine. ▪
Do not deactivate the safety devices or ignore warnings and alarms, be they communicated by the software or by ▪
warning labels fixed on the installation. Should the plates, adhesive labels, decals or any other warning sign on
the machine deteriorate they must be replaced.
It is not permitted for any reason whatsoever to modify, tamper with or alter the machine structure, the devices
▪
fitted, the operating sequence, etc. without prior consultation with the manufacturer.
All the routine and extraordinary maintenance operations must be recorded in the logbook noting down the date,
▪
time, type of operation, name of the operator and any other useful information.
In the event of faults or malfunctioning, contact your local distributor or the manufacturer. All the repair operations
▪
must be performed by qualified technicians.
It is strictly prohibited to clean the internal and external electrical parts of the wheel balancer with water.
▪
Exclusively use alcohol to clean the machine. Do not use any other chemical product. Do not under any circum- ▪
stances blast with compressed air.
Do not leave the machine exposed to the rain or the elements. The ambient storage and operating conditions must
▪
meet the requirements set out in the chapter INSTALLATION.
In the event of failure, deformation or malfunctioning of the safety devices, immediately replace them; “Makeshift”
▪
repairs are strictly prohibited. Use only original spare parts for which the machine has been designed and con-
structed.
The machine and the workplace must be kept perfectly clean.
▪
When the maintenance operations have been completed, before restoring the power supply, carefully check that ▪
you have not forgotten tools and/or other materials in the machine operating area. In any event, also during opera-
tion, no object may be placed on the protection shield.
2.6 EMERGENCIES
2.6.1 First aid
For any first aid follow the corporate regulations and conventional procedures.
2.6.2 Fire-fighting measures
Do not use water to extinguish fires, but only powder or carbon dioxide extinguishers. Preferably use extinguishers
filled with a special powder for metal fires.
Safety rules