CEMB USA ER85 Installation Manual - Manual (Page 6)

ENGLISH
Installation manual Rev. 03-2012
6
3.1 VISUAL INSPECTION
The packaging must be intact upon receipt, i.e.:
There must not be any sign of collision or breakage ▪
There must not be any sign that it was exposed to sources of heat, ice, ▪
water, etc.
There must not be any sign of tampering.
▪
Any deformations indicate that the machine was knocked about during
transport and may compromise proper machine functioning.
3.1.1 Checking the machine and equipment supplied
The main body of the machine, the relative accessories and the equipment
supplied (as agreed with the manufacturer) must be in perfect condition.
The supply is carefully checked before shipment, nevertheless it is advisable
to check upon receipt that it is complete and in order.
Check that:
The shipping data ▪ (addressee, number of packages, order number, etc.) correspond to the accompanying docu-
mentation.
The technical-legal documentation
▪ provided with the machine includes the instruction manual for the type of machine
to be installed as well as the EC declaration of conformity or, alternatively, the declaration of the manufacturer.
INFORMATION
In the event of defects and/or missing material immediately notify the manufacturer and follow his instructions
before proceeding with installation and startup.
3.2 UNPACKING
To remove the packaging refer to the “arrow” shown on the outside box.
Operate as follows to unpack the machine:
Cut the plastic safety straps 1.
Open the top of the cardboard box 2.
Remove the top protection 3.
Remove any protective corner pieces 4.
Remove the cardboard box pulling it upward 5.
Remove any protective “pluriball” 6.
Inspect the machine to check for any damage. Immediately inform the carrier and the supplier in the event of 7.
apparent damage.
Keep the packaging materials for possible future shipment of the machine.
INFORMATION
The packaging used is in compliance with the environmental requirements set out in the European packaging regula-
tions (Official EC Gazette, N. L. 365/19). The cardboard boxes can easily be recycled. The plastic wrappings are
made of materials free of hazardous metals. It is advisable to contact the competent local authority for their disposal.
3. Unpacking and positioning
Unpacking and positioning