CEMB USA ER85 Installation Manual - Manual (Page 7)

ENGLISH
Installation manual Rev. 03-2012
7
3.3 PACKING LIST
All the materials included in the supply are listed on the packing list. The contents may vary from machine to machine
depending on the sales agreements, the optional parts supplied, etc.
Generally, the supply includes:
the machine ▪
the toolbox ▪
the instruction manual ▪
3.4 STORAGE
When the machine:
is not immediately installed; ▪
is uninstalled and stored pending moving to another place ▪
position it in a covered place protected against direct contact with atmospheric agents and dust.
The permitted ambient values in the storage area are as follows:
Temperature: +5 to +40°C (41 - 104°F) ▪
Relative humidity: 30÷80 %. ▪
If taking the machine out of service after a period of use and after performing the necessary maintenance operations,
it can be stored for a period of not more than two years, provided that it is stored in a closed dust-free environment
without aggressive agents and with the following characteristics:
Ambient conditions as described above ▪
Positioned in such a way that it is protected against deformation, crushing, breakage, etc. ▪
Not subjected to knocks, vibrations, overhanging loads, etc. ▪
3.5 HANDLING
The term “handling” means unloading the machine from the means of
transport and positioning it in the place where it will be used. Upon receipt
the customer needs to unload the machine using his own means and store
it in a dry and protected place pending installation.
The machine is to be handled while still fastened on the wooden pallet
(see next paragraph) by suitably trained persons wearing the personal
protection devices described in Chapter 2.
WARNING
H ANDLE THE MACHINE WITH EXTREME CARE , LIFTING IT THE MINIMUM NECESSARY AND AVOIDING DANGEROUS OSCILLATION AND UNBALANCING .
B EFORE MOVING THE MACHINE , IT MUST BE TIED TO THE LIFT TRUCK ( OR TRANSPALLET ) TO PREVENT IT FROM SHIFTING AND TURNING OVER .
Before lifting the machine with a lift truck or transpallet, make sure that the forks are properly positioned and protrude
from the opposite side by at least 30 cm.
Unpacking and positioning