CEMB USA C75SE (B) - Manual (Page 13)

I 0292 - 12
I 0292 - 13
POS A
POS B
GB
GB
5.3 - PRESETTING OF WHEEL DIMENSIONS
5.3.1 AUTOMATIC PRESETTING
(see also CORRECTION MODE )
The screen appears upon removing the distance + diameter gauge.
The “dimension acquired” message is indicated by the correction weight symbol, which changes from
blue to red.
- INNER SIDE WEIGHT: Using the special grip, move the end of the gauge against the rim in position:
a)
Sprung weight : in one of the positions A/B indicated in figure 8.
INDICATOR
L.T. function enabled
(see Buttons
Enabled)
INDICATOR: Width
Sonar function
enabled
b) Adhesive weight: in the position indicated below
- Hold the gauge in position for at least 2 seconds.
If the acoustic signal is enabled (see Acoustic signal), the acquisition of the dimensions is accompanied
by a “beep”. Manual setting is possible using the buttons as described in Manual setting.
N.B.: Use pushbuttons and to select the type of weight to apply (see CORRECTION MODE )
Position of
adhesive
weight
Fig. 8
Fig. 9