Analog Way Pulse User Manual
Page 33
1/ In the Input Selection section, press the source button (#1 to #10)
of the source you wish to record as a logo. The source button will
start blinking.
2/ Select the Logos/Frames menu by scrolling through the menu
with the scroll knob, then pressing the
[ENTER]
button.
3/ Select Record Logos in the Logos/Frames menu by rotating
the scroll knob, then pressing
[ENTER]
. A small white rectangle
will appear on your main display, indicating the logo that will be
captured.
4/ Adjust logo size, position, and fine tune key attributes by rotating
the scroll knob and pressing
[ENTER]
to memorize logo settings.
5/ Select an empty logo memory (empty logos are indicated in the
sub-menu) to store the logo into. Press the
[ENTER]
button. The
PLS300
will display a progress status bar on the VFD screen.
6/ In the Layer Selection section, press the
[LOGO]
button, and
select logo number (#1 to #6) you wish to use. Your logo will
appear on the preview screen above any existing layer on screen.
7/ Press the
[TAKE]
button. Your logo will appear on the main display.
In Multi Layer Mixer mode, the
PLS300
offers a variety of mixer
type transitions, including wipes, fades, and cuts. The transitions,
transition times and fade/wipe effects can all be setup through the
PLS300
Layer menu.
Memorizing logos
Mixer functions
31