Analog Way Pulse - Manual (Page 54)

If you need to use your own Software Control program from a PC
or automation, the device allows communication through an ASCII
code protocol. All commands can be found on www.analogway.com,
in the [Technical Support] menu, [User’s Manuals] menu.
All Analog Way products equipped with an RS232 input are
compatible with Crestron, AMX, Medialon, and most major control
systems. TCP/IP control ports are also available on most Analog
Way products, as standard or as options.
To control a PLS300 product with an External Remote Controller (PC
Software Control - Touch Pad Controller…) follow the indications
below :
1/ In the “Control” - “LAN Setup” menu, configure the connection of
the PLS300 product in UDP mode and setup the Local and Remote
Addresses as well as the Local and Remote Ports in concordance
with your Network.
2/ Configure the TCP/IP address of your External Remote Controller.
In example: 192.168.000.001
3/ Setup the UDP connection of your External Remote Controller in
concordance with your Network.
4/ You can now control your PLS300 product with an External
Remote Controller.
7-3. EXTERNAL PROGRAMMING
52