Analog Way Pulse - Manual (Page 49)

It is possible to store up to 6 logos in the PLS300 non volatile
memory. Logos work in much the same way as frames, and can be
recorded from any of the PLS300 ’ 10 sources. Logos have more
attributes than frames. They can be sized, positionned, but also
keyed via color cutout selection or luma key.
1/ In the Input Selection section, click the source button (#1 to #10)
of the source you wish to record as a logo. Press [TAKE] to display
the input on the Main display.
2/ In the Logos/Frames tab, click Record Logo, then select an empty
logo memory slot (#1 to #6) to record your logo into.
3/ Adjust position, size and keying attributes for your logo.
4/ Click Execute to record your logo into the selected memory slot.
The PLS300 RCS will display a progress bar while recording the
logo.
5/ In the Input Selection section, click the [LOGO1] button, and select
logo number (#1 to #6) you wish to use. Your logo will appear on
the preview screen above any existing layer on screen.
6/ Click the [TAKE] button. Your logo will appear on the main display.
Working with logos
Memorizing logos
Layer transitions & effects
The PLS300 offers a wide variety of transitions between the scenes
you create for your shows and events. It allows for live recall of 4
user presets, each of which you can be edited at any given time.
1/ In the Layer Selection section, click the PIP button. On your Preview
screen, PIP1 will appear as a color rectangle. The parameters of
the layer will automatically appear in the RCS Preview section.
2/ At the bottom of the Preview section, click on the Transition tab,
then select the transition type from the left dropdown menu, and
the effect behaviour from the right dropdown menu.
3/ Determine the effect duration by sliding the duration bar left
(shorter) or right (longer), or by manualy setting the value in the
duration value box.
4/ Repeat the procedure in the Out Transition tab to determine the
way your layer will close.
47