Datamax-O'Neil Class Series II Programmer’s Manual - Manual (Page 137)

Extended System-Level Command Functions
Class Series 2 Programmer’s Manual 123
STX Kx Delete Configuration File
This command deletes a configuration file.
Syntax:
<STX>KxmName<CR>
Where:
m
- Valid Module ID – Range A to Z.
Name - The name, up to 16 characters, of the configuration
file.
<CR> - 0x0d terminates the name.
Sample:
<STX>KxYPlant1
The sample above deletes the configuration file Plant1 from
Module Y. (Remember to prefix this command with the Module
(Un)Protect Command <STX>Kp.)
STX KZ Immediately Set Parameter
This command immediately sets the specified parameter.
Syntax:
<STX>KZax<CR>
Where: a - Valid parameter identifier, as follows:
F = Feed Speed
P = Print Speed
S = Slew Speed
H = Heat Setting
x
- Speed Parameter Range – A to e (see Appendix L).
-or-
xx
- Heat Parameter Range – A two-digit value (00-30);
see the “H” Label Formatting Command.
Sample:
<STX>KZH22
The sample above causes the file currently being executed to
assume a Heat Value of 22.