Datamax-O'Neil Class Series II Programmer’s Manual - Manual (Page 150)

Label Formatting Command Functions
136 Class Series 2 Programmer’s Manual
S Set Feed Speed
This command controls the rate at which the label is moved through non-printed areas.
The setting remains unchanged unless another feed speed command is received or until
the printer is reset.
Syntax:
Sa
Where: a - Is a single alpha character representing a speed; see
Appendix L for valid ranges.
Sample: <STX>L
SE
141100001000100LABEL1<CR>
E
<STX>L
1411000010001000LABEL2<CR>
E
The sample above sets a 3 IPS feed speed and prints two labels,
with the same feed speed for both.
s Store Label Format in Module
This command stores a label format to a specified module as a .dlb file. Supplying the
module name will store the label to that module; otherwise, using C will cause the label
format to be stored in the selected default module (see <STX>X). In addition, this
command terminates the Label Formatting Command.
Syntax: sann…n
Where: a - Is the module designator representing a single
character module name; see Appendix K.
nn…n - Represents the name of the label (maximum 16
characters).
Sample:
<STX>L<CR>
D11<CR>
191100501000000123456789012<CR>
1911005020000001234567<CR>
191100500000000Sample<CR>
1X1100000000000B250250002002<CR>
Q0001<CR>
sATEST<CR>
The sample above stores a format in Memory Module A and
names it “TEST”. (To recall a label format from the module use
the “r” command.)